Volkswagen Polo Owners Manual: Stopping the engine

Volkswagen Polo Owners Manual / Starting the engine, changing gear and parking / Starting and stopping the engine / Stopping the engine

First read and observe the introductory information and safety warnings

The steps should only be carried out in the specified order.
1.	The vehicle must be completely stationary .
2.	Press the brake pedal. Keep it held down until step 4 has been completed.
3.	In an automatic gearbox, move the selector lever to position P.
4.	Apply the handbrake firmly .
5.	Turn the vehicle key to position .
6.	In vehicles with a manual gearbox, select first gear or reverse.

WARNING

Never switch off the engine while the vehicle is in motion. This can lead to a loss of vehicle control, accidents and serious injuries.

The airbags and belt tensioners will not work if the ignition is switched off.

The brake servo will not work when the engine is switched off. More force is required on the brake pedal to stop the vehicle.

The power steering will not function if the engine is switched off, and more force will be required to steer the vehicle.

If the vehicle key is removed from the ignition, the steering lock can activate and you will no longer be able to steer the vehicle.

NOTICE

If the vehicle has been driven at high load for a long period, the engine could overheat when it is switched off. In order to avoid damage to the engine, allow the engine to run in neutral for approximately two minutes before switching it off.

In vehicles with an automatic gearbox, the vehicle key can only be removed from the ignition lock if the selector lever is in position P.

After the engine is switched off, the radiator fan in the engine compartment may run on for some minutes, even if the ignition is switched off or the vehicle key has been removed. The radiator fan will switch itself off automatically.

Starting the engine

First read and observe the introductory information and safety warnings The steps should only be carried out in the specified order. Step ...

Electronic immobilizer

First read and observe the introductory information and safety warnings The immobilizer helps to prevent the engine from being started and driven with an unauthorised vehicle key. There is a c ...

Other materials:

Introduction
This chapter contains information on the following subjects: → Indicator lamp → Information on changing bulbs → Removing and installing the headlights → Changing bulbs in the front headlights (halogen H4) → Changing bulbs in the front headlights (halo ...

Controls for the heating and fresh air system
Fig. 127 In the centre console: rotary controller of the heating and fresh air system with controls First read and observe the introductory information and safety warnings Button, control Additional information. Heating and fresh air system ...

Flat Connector Systems
Note If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to → Chapter „Secondary Lock“. ...