Volkswagen Polo Owners Manual: Starting the engine with jump leads

Changing bulbs in the side turn signals

Fig. 188 Removing the side turn signal bulb Fig. 189 Side turn signal: changing the bulb First read and observe the introductory information and safety warnings Depending on the vehicle, th ...

Introduction

This chapter contains information on the following subjects:  → Positive and earth jump lead connection points  → How to start the engine using jump leads If the engine fails to sta ...

Other materials:

Reinforced Shock Absorbers and Coil Springs
Reinforced shock absorbers and coil springs on the vehicle rear axle reduce pitching motions between the vehicle and the trailer. If not already installed in the factory, these shock absorbers and springs can often be retrofitted at authorized Volk ...

A/C Service Station, Emptying
  Caution If it is suspected that chemicals were added to the refrigerant circuit to seal leaks, do not connect the A/C service station and do not extract the refrigerant. ...

Overview - Tire Pressure Monitoring Sensor without Valve
1 -  Valve Cap 2 -  Nut Individual component of -item 7- → Item Tightening specification. Refer to → Anchor. Always replace if removed 3 -  W ...