VW Polo manuals

Volkswagen Polo Service & Repair Manual: Severely Discharged Battery, Charging with Battery Charger -VAS5095A

  WARNING
Risk of injury. Follow all Warnings and Safety Precautions. Refer to → Chapter „Warnings and Safety Precautions“.
The charger recognizes the severely discharged battery automatically and starts the charging process conservatively with low charging current. The charge current is automatically adjusted to the battery charge state.
  Note
Observe the notes in chapter. Refer to → Chapter „Severely Discharged Batteries“.
Severely discharged batteries in vehicles must be replaced prior to delivery. Pre-existing damage cannot be ruled out.
The battery voltage must be at least 0.6 V!
  WARNING
Batteries that have a light yellow visual indicator do not have to be tested or charged. Jump starting must not be used!
There is a risk of explosion during testing, charging or jump starting.
These batteries must be replaced.
–  Charge the battery. Refer to → Chapter „Battery, Charging with Battery Charger -VAS5095A-“.
   
Battery, Charging with Battery Charger -VAS5095A
Special tools and workshop equipment required Battery Charger -VAS5095A-   WARNING ...

Support Mode with Battery Charger -VAS5095A
General Information The support mode provides the vehicle electrical system with voltage when the battery is removed or disconnected. ...

Other materials:

Charging, replacing, disconnecting and connecting the vehicle battery
First read and observe the introductory information and safety warningsCharging the battery The vehicle battery should be charged by a qualified workshop, as the technology used in factory-fitted batteries requires voltage-limited charging . Volkswagen recommends using a Volkswagen dealership ...

Legal Requirements
The manufacturer is granted general type approval for the whole vehicle including all parts and for specific retrofitting (general type approval according to § 20 StVZO (Motor Vehicle Construction and Use Regulations or EU type approval). ...

Diagonal Washouts
Diagonal wear spots on tires Diagonal wear spots run at an angle of approximately 45° with respect to the plane of circumference. They usually occur once, but may also occur several times along the tire circumference. ...

© 2016-2026 Copyright www.vwpolo.net