Volkswagen Polo Service & Repair Manual: Service Test, Performing
Note
The printed test results can differ depending on the
software version. |
Read the Battery Tester -VAS6161- Operating Instructions. |
WARNING
Do not check or charge batteries that have a visual
indicator that is bright yellow. Jump starting must not
be used! |
There is a risk of explosion during testing,
charging or jump starting. |
These batteries must be replaced. |
|
– |
Select “at the battery pole” or “at the battery jump start
terminal”. |
– |
Select the type of battery: “standard”, “AGM”, “2*6V” or
“Gel”. |
– |
Select the “CCA”, “JIS”, “DIN”, “SAE”, “IEC” or “EN”. |
– |
Measure the temperature. Hold the temperature sensor
approximately 5 cm above the battery pole until the temperature
is stable. |
– |
Print out the test report if necessary. |
|
|
|
WARNING
Do not check or charge batteries that have a visual
indicator that is bright yellow. Jump starting must not
...
1 -
Type of test.
2 -
Battery test result.
3 -
Measured voltage
...
Other materials:
AGM Battery, Checking
Perform Battery Checks in the Following Sequence:
1.
Visual inspection. Refer to
→ Chapter „Visual Inspection“.
2.
Check the battery using the Battery Tester -VAS6161-. Refer
to
...
Cracking
Cracking is the term for shallow cracks in the sidewall of
the tire.
They run starting from the bulge in the direction of the
tire shoulder. See Illustration for the mentioned components.
Refer to
→ Fig. „“Components ...
Operating ParkPilot
Fig. 120 In the rear bumper: ParkPilot
ultrasound sensors
First read and observe the introductory information
and safety warnings The ParkPilot uses ultraound sensors to
determine the distance between the rear bumper and an obstacle. There are 4 ultrasound
sensors in the rear bumper ...
© 2016-2024 Copyright www.vwpolo.net