VW Polo manuals

Volkswagen Polo Service & Repair Manual: Run-Flat Tire, Retrofitting/Conditions for use of Run-Flat Tires

  Caution
Using run-flat tires on vehicles is permitted only if the run-flat tire is supplied with the vehicle either as standard equipment or as an option.
Because pressure loss in a run-flat tire is not always visible, these tires should only be used on vehicles equipped with a tire pressure monitoring system. This system warns the driver when the tire pressure falls below a certain value.
The following are permitted:
Direct measuring systems. Refer to → Suspension, Wheels, Steering; Rep. Gr.44.
Indirect measuring systems. Refer to → Suspension, Wheels, Steering; Rep. Gr.44.
Only mount run-flat tires on disc wheels with an extended double hump (extended hump - EH2). Refer to → Chapter „Identification“.
Pay close attention to the installation instructions. Refer to → Chapter „Tires, Mounting“.
Do not install both run-flat tires and standard tires, even if the two tires on each axle will be the same.
A standard tire can only be installed in exception cases for a short time or a limited driving distance. The specific characteristics designed for driving with a flat tire will not be available. The driver must be informed of this.
Always Pay Attention to the Recommended Tire Brand. Refer to → Wheel and Tire Guide; Rep. Gr.44.
   
Run-Flat Tire, General Information
Run-flat tires have a reinforced sidewall in comparison to standard tires. This reduces the tendency for the sidewall to roll when there is a loss of pressure and pre ...

Run-Flat Tire PAX
  WARNING Run-flat tires must be replaced after they have gone flat. Pay cl ...

Other materials:

Upgrade Kit For VAS1978 -VAS1978/50
The Upgrade Kit For VAS1978 -VAS1978/50- is required in order to bring the “old”Wiring Harness Repair Set -VAS1978- up to the new standard of the Wiring Harness Repair Set -VAS1978A-. The upgrade kit contains four assembly- and ten release tools as w ...

Introduction
This chapter contains information on the following subjects:  → Preparing for a journey and driving safely  → Driving abroad  → Driving through water on roads Depending on where the vehicle is used, it could be a good idea to have an engine and transmission guard insta ...

Stopping the engine
First read and observe the introductory information and safety warnings  The steps should only be carried out in the specified order. 1. The vehicle must be completely stationary  . 2. Press the brake pedal. Keep ...

© 2016-2025 Copyright www.vwpolo.net