Volkswagen Polo Service & Repair Manual: Restrictor

Volkswagen Polo Service & Repair Manual / Refrrigerant R134a Servicing / Refrigerant Circuit General Information / Refrigerant Circuit Components / Restrictor

Caution

Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the system.

Only use tools and materials approved by the manufacturer.

The warranty is voided if non-approved tools or materials are used.

All components of the refrigerant circuit submitted for quality observation are always to be sealed (use original sealing caps of original part).

Replace damaged or leaking components of refrigerant circuit. Refer to → Chapter „Components, Replacing“.

To date, the original parts (compressor, reservoir, receiver/dryer, evaporator and condenser) have been filled with nitrogen gas. This charge is being gradually discontinued. There is little or no pressure equalization when removing the sealing plugs from the original part.

The restrictor creates a constriction. This restriction reduces the flow and creates high and low pressure sides in the refrigerant circuit. Before the restrictor the refrigerant which is under a higher pressure is warm. After the restrictor the refrigerant which is under a low pressure is cold. Before the restriction there is a strainer for contaminants and after the restriction there is a strainer, to atomize the refrigerant before it reaches the evaporator.

Note

Arrow -A- on restrictor points to evaporator.

Replace after each opening of the circuit.

Note different versions.

Refer to → Rep. Gr.87.

Refer to the Parts Catalog.

Restrictor

Reservoir

Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the sys ...

Receiver/Dryer

Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the sys ...

Other materials:

Loading the load carrier system
First read and observe the introductory information and safety warnings Loads can be attached securely only when the mounts, roof bars and load carrier system are fitted correctly . Maximum permissible roof load The maximum permitted roof load is 75 kg. The roof load limit refers to the c ...

Wheel cover
Fig. 163 Removing press-on wheel covers Fig. 164 Removing bolted-on wheel covers First read and observe the introductory information and safety warnings Removing and fitting press-on wheel covers Take the box spanner and wire hook from the toolkit . Insert the wire hook into o ...

Two-Part Wash Primer
Definition: Two-Part Wash Primer -LLS MAX 230 M1-, olive green (250 ml) Edition 12/2013 Product Description The Two-Part Wash Primer -LLS MAX 230 M1- is a zinc chromate-free, ...