Volkswagen Polo Owners Manual: Removing the ball coupling
First read and observe the introductory information
and safety warnings
- Unhitch the trailer .
- Remove the cover from the lock on the handwheel.
- Insert the key ⑧ into the lock and turn it clockwise.
- Hold the ball coupling tightly in your left hand .
- Use your right hand to pull out the handwheel ⑦ in the direction of arrow 1 and keep it in this position.
- Turn the handwheel ⑦ in the direction of arrow 2 until it engages.
- Keep the handwheel in this position and guide the ball coupling downwards out of the mounting. The ball coupling is now in the ready position.
- Let go of the handwheel and stow the pre-tensioned ball coupling safely with the vehicle toolkit.
- Pivot the trailer socket back fully from left to right to prevent soiling and damage to the mounting.
- Insert the sealing plug into the ball coupling mounting.
- Place the cover onto the bumper.
WARNING
- Only unlock the ball coupling once the trailer has been unhitched.
Fitting the removable ball coupling
Fig. 91 Overview: removable ball coupling
First read and observe the introductory information
and safety warnings
The removable ball coupling is located under the luggage compartment floor with ...
Hitching and connecting the trailer
First read and observe the introductory information
and safety warnings
Emergency breakaway cable
Always fasten the trailer's emergency breakaway cable properly to the towing
vehicle. Leave eno ...
Other materials:
Electronic immobilizer
First read and observe the introductory information
and safety warnings The immobilizer helps to prevent the engine
from being started and driven with an unauthorised vehicle key.
There is a chip in the key. It automatically deactivates the immobilizer when
the vehicle key is inserted into ...
Introduction
This chapter contains information on the following subjects:
→ Ignition lock
→ Starting the engine
→ Stopping the engine
→ Electronic immobilizer
Notes in this chapter concerning the automatic gearbox are applicable
both for the automatic gearbo ...
Beru Wheel Electronics Tire Pressure Monitoring Sensor, Removing and
Installing
Overview, Beru System
WARNING
If tire sealant was used, then the wheel electronics
on that particular wheel must be replaced.
WA ...
