VW Polo manuals

Volkswagen Polo Service & Repair Manual: Product Characteristics

Refrigerants used in motor vehicle air conditioning systems belong to the new generation of refrigerants based on chlorine-free, partially fluorinated hydrocarbons (H-FKW, R134a).
With regard to their physical properties, these are refrigerants which have been liquefied under pressure. They are subject to the regulations governing pressure vessels and use is only to be made of approved and appropriately marked containers.
Compliance with specific conditions is required to ensure safe and proper use.
   

Handling Refrigerant

  WARNING
There is a danger of ice-up.
The refrigerant can then escape as a fluid or vapor.
Do not open containers which store refrigerant.
If refrigerant vessels are opened, the contents may escape in liquid or vapor form. This process is intensified the higher the pressure in the vessel.
The pressure level is governed by two factors:
The type of refrigerant in the vessel. “The lower the boiling point, the higher the pressure.”
The temperature level. “The higher the temperature, the higher the pressure.”
   

Protective Eyewear

Put on protective goggles. They prevent refrigerant getting into the eyes, as this could cause severe injury from exposure to cold.

Protective Gloves and Clothing

Greases and oils dissolve readily in refrigerants. They would therefore destroy the protective layer of grease if allowed to come into contact with the skin. Degreased skin is however sensitive to the cold and germs.

Fluid Refrigerant and Skin Precaution

The refrigerant draws heat for evaporation from the surrounding area. Even if this is the skin. This may cause extremely low temperatures. Local frost bite may result (boiling point of R134a: -26.5 °C (-15.7 °F) at ambient pressure).

Do Not Breath In Refrigerant Vapor

  Note
If highly concentrated refrigerant vapor escapes, it mixes with the surrounding air and displaces the oxygen necessary for breathing.
Smoking Hazard

A burning cigarette can cause refrigerant to decompose. The resultant substances are toxic and must not be inhaled.

Safety Precautions
General Safety Precautions As per VBG 20, German industrial liability insurance association. Follow th ...

Welding and Soldering on Refrigeration Systems
Before performing welding or soldering work on vehicles near the air conditioning system components, extract the refrigerant and remove the residue by flushing with c ...

Other materials:

Checklist
The following actions must always be carried out in the given order in preparation for filling a tyre : If you get a flat tyre, park your vehicle on a firm and level surface at a safe distance from the flow of traffic. Apply the handbrake firmly Braking, stopping and parking B ...

Battery Terminal Clamp and Battery Terminal, Cleaning
Special tools and workshop equipment required Torque Wrench 1331 5-50Nm -VAG1331- The Contact Surface Cleaning Set -VAS6410- makes optimal repair quality possible in the realm of vehicle electronics. Using th ...

Overview - Tire Pressure Monitoring Sensor without Valve
1 -  Valve Cap 2 -  Nut Individual component of -item 7- → Item Tightening specification. Refer to → Anchor. Always replace if removed 3 -  W ...

© 2016-2024 Copyright www.vwpolo.net