Volkswagen Polo Service & Repair Manual: Overview - Wheel, RAX

Volkswagen Polo Service & Repair Manual / Whels, Tires, Whel Alignment / Component Overview / Overview - Wheel, RAX

Overview - Wheel, RAX

1 -

Wheel

Installing the wheel. Refer to → Chapter „Wheel, Mounting“.

2 -	Wheel Bolts

There are different versions. Refer to → Chapter „Wheel Bolts“.

3 -

PAX Tires

Side Wall Lettering. Refer to → Chapter „Run-Flat Tire (PAX), Lettering On Side Wall“.

4 -	Support Ring

5 -	Wheel for PAX Tires

Note assembly instructions. Refer to → Chapter „Tires, Mounting“.

6 -	Metal Valve Body

Refer to the Parts Catalog for the allocation of the only valves to be installed.

delivered complete

7 -	Wheel Electronics

Batteries must be completely replaced.

Remaining battery life, temperature and pressure can be read via diagnosis with Vehicle Diagnostic Tester.

Beru wheel electronics system. Refer to → Chapter „Beru Wheel Electronics Tire Pressure Monitoring Sensor, Removing and Installing,“.

Siemens wheel electronics system. Refer to → Chapter „Siemens Wheel Electronics Tire Pressure Monitoring Sensor, Removing and Installing“.

8 -	Adhesive Balancing Weights

Maximum 60 grams per rim permitted

Clean wheel where it will be adhered so it is free of dirt and grease

Remove protective film.

Attach balance weights to intended surfaces.

9 -	Anti-Theft Wheel Bolts

Note assembly instructions. Refer to → Chapter „Wheel Bolts“.

Operating. Refer to → Fig. „“Anti-Theft Wheel Bolts”“

10 -	Adapter for the Anti-Theft Lockable Wheel Bolt

Place on wheel bolt. Refer to → Fig. „“Anti-Theft Wheel Bolts”“

11 -	Anti-Theft Wheel Bolt Cap

12 -	Wheel Bolt Cap

13 -	Wheel Bolts

Note

Make sure the correct wheel bolts are installed. Refer to the Parts Catalog.

Note assembly instructions. Refer to → Chapter „Wheel Bolts“.

14 -

Hub Cap

Removing and Installing. Refer to → Chapter „Hub Cap for Alloy Wheels with Open Threaded Connection, Removing and Installing“.

Overview - Wheel, Standard

1 - Wheel Installing the wheel. Refer to → Chapter „Wheel, Mounting“. 2 - Wheel Bolts There a ...

Other materials:

Test after driving for 10 minutes
First read and observe the introductory information and safety warnings Reconnect the tyre filler hose and check the tyre pressure on the tyre pressure display ⑥. 1.3 bar (19 psi / 130 kPA) and lower: Do not drive on! The tyre cannot be sealed adequately with the breakdown set. ...

Roll-back function for the electric windows
First read and observe the introductory information and safety warnings The roll-back function for the electric windows can reduce the risk of injuries when the windows are closing . If the one-touch closing function for a window does not work because it is stiff or is being obstructed, the w ...

Welding and Soldering on Refrigeration Systems
Before performing welding or soldering work on vehicles near the air conditioning system components, extract the refrigerant and remove the residue by flushing with compressed air and nitrogen. The products of refrigerant decomposition d ...