Volkswagen Polo Owners Manual: Overview of the menu structure
First read and observe the introductory
information and safety warnings
- MFD (multifunction display)
- Driving time
- Current fuel consumption (Curr. fuel con.)
- Average fuel consumption (Av. consumption)
- Fuel range
- Distance
- Average speed
- Digital speed display
- Digital oil temperature display
- Speed warning function
- Audio ⇒ BookletRadio, or ⇒ BookletNavigation system,
- Navigation ⇒ BookletNavigation system,
- Telephone ⇒ BookletProvision for a mobile telephone,
- Veh. status
- Settings
- Language
- MFD data
- Driving time
- Current fuel consumption (Curr. fuel con.)
- Average fuel consumption (Av. consumption)
- Distance
- Average speed
- Digital speed display
- Digital oil temperature display
- Speed warning function
- Time
- Hours
- Minutes
- 24h mode
- Summer time
- Winter tyres
- active
- +10 km/h
- -10 km/h
- Units
- Temperature
- Consumption per journey
- Second speed display on/off
- Travel mode
- Service
- Information
- Reset
- Factory setting
Introduction
With the ignition switched on, the different display functions can be
accessed via the menus.
There are no buttons on the windscreen wiper lever in vehicles equipped with
a multifunction steerin ...
Using the menus in the instrument cluster
Fig. 13 Vehicles without multifunction
steering wheel: press button ① in the windscreen wiper lever to confirm the menu
point and rocker switch ② to change the menu
Fig. 14 Vehicles with mul ...
Other materials:
Wire Break with Single Repair Point
Repair point with single crimp connection
–
Free up wire intended for repair (approximately 20 cm to
both sides of repair point).
–
If required, remove wiring harness wrapping using a folding
...
Filling the tank with petrol or diesel
Fig. 130 In the right-hand side of the
vehicle at the rear: tank flap open
Fig. 131 Open tank flap with tank cap attached
to the holder
First read and observe the introductory information
and safety warnings Switch off the engine, ignition and the
mobile telephone before filling the ta ...
Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
