VW Polo manuals

Volkswagen Polo Owners Manual: Opening or closing the windows electrically

Volkswagen Polo Owners Manual / Opening and closing / Electric windows / Opening or closing the windows electrically

Fig. 32 In the driver door: buttons for the front and rear electric windows with one-touch opening and closing.

First read and observe the introductory information and safety warnings

Buttons in the driver door with one-touch opening and closing

Key for :

  1. Buttons for the windows in the front doors.
  2. Buttons for the windows in the rear doors.
  3. Safety button for switching the electric childproof lock on and off.

Opening and closing windows with one-touch opening and closing

Function Action
Opening Press the  button.
Closing Pull the  button.
Stopping the one-touch function Press or pull the button for the appropriate window again.
The safety switch disables the electric window buttons in the rear doors. The yellow indicator lamp in the button will light up.

The windows can still be operated using the buttons several minutes after the ignition has been switched off, provided that the driver door and front passenger door are not opened. If the vehicle key is removed from the ignition lock and the driver door is opened, all electric windows can be opened or closed by operating and holding the corresponding window button in the driver door. After a few seconds, convenience opening/closing is started .

Introduction
This chapter contains information on the following subjects:  → Opening or closing the windows electrically  → Electric windows – functions  → Roll-back function for the ele ...

Electric windows – functions
First read and observe the introductory information and safety warnings One-touch opening and closing One-touch opening and closing makes it possible to fully open and close the windows. The ind ...

Other materials:

Hub Cap for Alloy Wheels with Open Threaded Connection, Removing and Installing
Removing The wheel is removed.   Note     Hold the cap secure -1- with the hammer. Installing   ...

Adhesive Surface Pretreatment when Replacing Laser-Soldered Roofs
 Dry sand the cataphoretic primer on the roof adhesive surface -item 6- → Item down to the bare metal using P180 sandpaper.   –  Dry sand the roof pillar adhesive surface ...

Threaded Connections, Repairing
Special tools and workshop equipment required Torque Wrench 1331 5-50Nm -VAG1331-   Note Do not use rust remover, contact spray or grease because the lack of friction will cause the torque to be ...

© 2016-2024 Copyright www.vwpolo.net