VW Polo manuals

Volkswagen Polo Service & Repair Manual: O-Ring

  Caution
Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the system.
Only use tools and materials approved by the manufacturer.
The warranty is voided if non-approved tools or materials are used.
All components of the refrigerant circuit submitted for quality observation are always to be sealed (use original sealing caps of original part).
Replace damaged or leaking components of refrigerant circuit. Refer to → Chapter „Components, Replacing“.
To date, the original parts (compressor, reservoir, receiver/dryer, evaporator and condenser) have been filled with nitrogen gas. This charge is being gradually discontinued. There is little or no pressure equalization when removing the sealing plugs from the original part.
   
These o-rings seal off the connection points between individual components of the refrigerant circuit.
Only O-rings that are resistant to refrigerant r134a and refrigerant oil must be installed. Make sure they are original replacement parts.
Refer to the Parts Catalog.
O-ring:
Always use only once.
Make sure diameters -a- and -b- are correct.
Coat with refrigerant oil before installing
  Note
The color coding of refrigerant circuit o-rings with R134a has been discontinued. Colored and black O-rings are used.
Refer to → Rep. Gr.87.
Refer to the Parts Catalog.
 

O-Ring

Expansion Valve
  Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the sys ...

Refrigerant Circuit Pipes and Hoses
  Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the sys ...

Other materials:

Retrofitting two-way radios
First read and observe the introductory information and safety warningsYou will need an external aerial to use a two-way radio in the vehicle. Any retrofit installation of electrical or electronic equipment in the vehicle will affect its vehicle type approval. Under certain circumstances, thi ...

Correct sitting position
Fig. 35 There must be a distance Ⓐ of at least 25 cm between the driver and the steering wheel. Fig. 36 Correct seat belt routing and head restraint adjustment First read and observe the introductory information and safety warnings The following details the correct sitting positions for ...

Description of the central locking system
First read and observe the introductory information and safety warnings The central locking system enables you to lock and unlock all the doors, the tailgate and tank flap from one central point: From outside the vehicle with the vehicle key . From inside the vehicle with the centra ...

© 2016-2026 Copyright www.vwpolo.net