VW Polo manuals

Volkswagen Polo Service & Repair Manual: Maintenance Test, Performing

  WARNING
Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not be used!
There is a risk of explosion during testing, charging or jump starting.
These batteries must be replaced.
–  Select “Maintenance Test”.
–  Connect the scanner.
  Note
If there is no scanner, manually enter the VIN on the printed test results.
–  Scan the VIN.
–  Select “at the battery pole” or “at the battery jump start terminal”.
–  Scan in the battery 2D code or manually select the type and manufacturer in the menu.
–  Measure the temperature. Hold the temperature sensor approximately 5 cm above the terminal connection until the temperature is stable.
–  Start the test.
–  Print out the test report if necessary.
   
Warranty Test, Performing
  WARNING Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not ...

Service Test, Performing
  Note The printed test results can differ depending on the software version. Read the Battery Tester -VAS6161- Operating In ...

Other materials:

Checking with Restrictor, Reservoir and A/C Compressor Regulator Valve -N280-, Externally Regulated A/C Compressor
  Note Connecting service station. Refer to → Chapter „Connecting Service Station“. Observe test requirements. Refer to → Chapter „Pressures, Checking“. –  ...

Antenna Wires, Repairing
Aerial Cable Repair Set -VAS6720 Special tools and workshop equipment required Repair Set, Aerial Cable -VAS6720- Checking the Antenna Wire. Refer to Replacing the Tool Head. Refer to ...

Locking the front passenger door and rear doors manually
Fig. 156 In the end face of the right-hand door: manual lock covered by a rubber seal Fig. 157 Manually locking the vehicle with the vehicle key First read and observe the introductory information and safety warnings If the vehicle has a lock cylinder in the door handle of the front passe ...

© 2016-2026 Copyright www.vwpolo.net