VW Polo manuals

Volkswagen Polo Service & Repair Manual: Magnetic Clutch High Pressure Switch -F118

  Note
For switching pressures, removing and installing switches and switch arrangement and version, see vehicle-specific refrigerant circuit.
Refer to → Rep. Gr.87.
   
Function:
Switches off A/C compressor when there is excessive pressure in the refrigerant circuit (approximately 32 bar (464 psi)).
 

Magnetic Clutch High Pressure Switch -F118

A/C Refrigerant High Pressure Switch -F23
  Note For switching pressures, removing and installing switches and switch arrangement and version, see vehicle-specific refrigerant circuit. ...

A/C Refrigerant Low Pressure Switch -F73
  Note For switching pressures, removing and installing switches and switch arrangement and version, see vehicle-specific refrigerant circuit. ...

Other materials:

Refuelling autogas
Fig. 132 In the right-hand side of the vehicle at the rear: open tank flap with tank cap for gas filler neck ① and adapter ② First read and observe the introductory information and safety warnings Switch off the engine, ignition and mobile telephone before refuelling  . Please re ...

Single Wire Seals, Installing
  Note Single wire seals prevent the penetration of water and dirt into the contact housing. They are installed, for example, in the engine compartment and must be reinstalled after a repair. Single wire seal is crimpe ...

Refrigerant, Keeping Records
  Note The laws and regulations listed below are applicable in Germany. Different or additional laws and regulations may apply in other countries. Addresses in other countries can be obtained from the relevant au ...

© 2016-2026 Copyright www.vwpolo.net