Volkswagen Polo Owners Manual: Locking the front passenger door and rear doors manually
Fig. 156 In the end face of the right-hand door: manual lock covered by a rubber seal
Fig. 157 Manually locking the vehicle with the vehicle key
First read and observe the introductory
information and safety warnings
If the vehicle has a lock cylinder in the door handle of the front passenger door, manual locking is carried out in the same way as for the driver door .
The front passenger door and the rear doors can be locked manually. This does not activate the anti-theft alarm.
- Open the door.
- Remove the rubber seal from the end face of the door. The seal is marked
by a lock symbol
.
- Fold the key bit out of the vehicle key .
- Insert the opened key bit into the slot and turn the vehicle key away from the vehicle in the direction of the arrow .
- Put the rubber seal back in place and close the door fully.
- Ensure that the door is locked.
- If required, repeat the process for the other doors.
- The vehicle should be checked by a qualified workshop as soon as possible.
The doors can be unlocked and opened from the inside by pulling the door release handle. You may have to pull the door release lever twice .
Locking or unlocking the driver door manually
Fig. 155 Door handle on driver
door with lock cylinder
First read and observe the introductory
information and safety warnings
If locked manually, all doors are locked. If unlocked manually, on ...
Unlocking the tailgate manually
Fig. 158 In the luggage
compartment: manual release for the tailgate
First read and observe the introductory
information and safety warnings
If necessary, fold the backrest of the rear bench ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Notes on tow-starting
→ Notes on towing
→ Fitting the front towing eye
→ Rear towing eye
→ Driving tips when towing
Comply with any legal requirements when towing and tow starting.
For t ...
Reinforced Shock Absorbers and Coil Springs
Reinforced shock absorbers and coil springs on the vehicle
rear axle reduce pitching motions between the vehicle and the
trailer. If not already installed in the factory, these shock
absorbers and springs can often be retrofitted at authorized
Volk ...
Evaporator Vent Temperature Sensor -G263- or Evaporator Temperature Sensor
-G308
Function:
The Evaporator Vent Temperature Sensor -G263- or Evaporator
Temperature Sensor -G308- determines the temperature behind the
evaporator. This value goes to the air conditioning control
module and serves as a reference signal for ...
