Volkswagen Polo Owners Manual: Lights and vision – functions
First read and observe the introductory information
and safety warnings
Parking light
Depending on the vehicle equipment level, when the parking lights (left and right turn signals) are switched on, the headlight and the tail light on the corresponding side of the vehicle light up. The parking light only lights up when the ignition is switched off and if the turn signal and main beam lever was in the central position before being operated.
Daytime headlights
With daytime headlights, the dipped beam headlights or side lights and the number plate are lit up.
When the light switch is in position
, the daytime headlights are switched
on every time the ignition is switched on. In some model versions, the
indicator lamp in the light switch
indicates that the daytime headlights are switched on.
The daytime headlights cannot be switched on or off manually.
Daytime running lights
There are separate lights in the headlights or in the front bumper for the daytime running lights.
Only the separate lights light up when the daytime running lights are switched on .
When the light switch is in position
, the daytime running lights are
switched on every time the ignition is switched on.
Static cornering light
When cornering slowly or travelling around very tight bends, a static cornering light is switched on automatically. The static cornering light is integrated into either the fog light or the front headlight, and only lights up at speeds below approximately 40 km/h (25 mph).
When reverse gear is engaged, the static cornering light on both sides of the vehicle may switch on to provide better illumination of the area when manoeuvring.
Lights with LED technology
The LEDs cannot be replaced. Seek expert assistance. Volkswagen recommends using a Volkswagen dealership for this purpose.
WARNING
- Never drive with daytime running lights if the street is not sufficiently lit due to weather and lighting conditions. The daytime running lights are not bright enough to illuminate the road ahead and to ensure that other road users are able to see you.
- The rear lights will not be switched on with the daytime running lights. If the rear lights are not switched on, the vehicle may not be visible to other road users if it is dark, raining, or if visibility is poor.
In cool or damp weather, the interior of the headlights, rear lights and turn signals may mist up briefly. This is normal and does not affect the service life of the lights on your vehicle.
Switching lights on and off
Fig. 68 Next to the steering wheel: examples
of the various light switches
First read and observe the introductory information
and safety warnings
Observe any country-specific regulations when ...
Masking or switching over headlights for driving abroad (travel mode)
First read and observe the introductory information
and safety warnings
If you have to drive a right-hand drive vehicle in a left-hand drive country,
or vice versa, the asymmetric dipped beam hea ...
Other materials:
A/C Compressor Regulator Valve -N280
Note
For switching pressures, removing and installing switches
and switch arrangement and version, see vehicle-specific
refrigerant circuit.
Refer to
→ Rep. Gr.87.
...
CAN Bus Wires, Repairing
Unshielded two-strand wiring -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
can be used as CAN bus wiring.
The color coding of CAN bus wires can be found in the
following table:
...
Towing a trailer
First read and observe the introductory information
and safety warnings
Headlight adjustment
Towing a trailer can raise the front end of the vehicle enough for the dipped
beam to blind other road users. Use the headlight range control to lower the light
cone as required. If you do not have ...
