Volkswagen Polo Service & Repair Manual: Leaks or Internal Damage, for Example Noises or No Output
Note
For vehicles with an electrically-driven A/C compressor,
de-energize the high voltage system before removing the A/C
compressor. Refer to
→ Electrical System Hybrid; Rep. Gr.93. |
– |
Discharge the refrigerant circuit. |
– |
Remove the A/C compressor. |
Note
In the case of internal damage (on A/C compressor), flush
refrigerant circuit with refrigerant R134a. Refer to
→ Chapter „Refrigerant Circuit, Flushing (Cleaning) with
Refrigerant R134a“. |
If a different A/C compressor is installed with a different
refrigerant oil, the refrigerant circuit is to be flushed with
refrigerant R134a. Refer to
→ Chapter „Refrigerant Circuit, Flushing (Cleaning) with
Refrigerant R134a“. |
– |
Replace receiver/dryer/dryer cartridge and expansion valve
or reservoir and restrictor. |
– |
If a leak is present, check the expansion valve for debris
or corrosion and replace if necessary. |
– |
Assemble, evacuate and charge the refrigerant circuit. |
|
|
|
Note
For vehicles with an electrically-driven A/C compressor,
de-energize the high voltage system before removing the A/C
compressor. Refer to
...
Other materials:
Diagonal Washouts
Diagonal wear spots on tires
Diagonal wear spots run at an angle of approximately 45°
with respect to the plane of circumference.
They usually occur once, but may also occur several times
along the tire circumference.
...
Evacuating and Charging Valve, Low Pressure Side
Special tools and workshop equipment
required
Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench
1783 - 1/4" Drive Ratchet -VAS6234-
WARNING
There is a dan ...
Warning and indicator lamps
The warning and indicator lamps indicate various warnings , faults or certain
functions. Some warning and indicator lamps light up when the ignition is
switched on and should go out once the engine is running or the vehicle is in
motion.
Depending on the vehicle's equipment level, additional ...
© 2016-2025 Copyright www.vwpolo.net
