Volkswagen Polo Owners Manual: Introduction

Volkswagen Polo Owners Manual / Tow-starting and towing / Introduction

This chapter contains information on the following subjects:

→ Notes on tow-starting
→ Notes on towing
→ Fitting the front towing eye
→ Rear towing eye
→ Driving tips when towing

Comply with any legal requirements when towing and tow starting.

For technical reasons, vehicles with a discharged battery must not be tow-started.

Towing a vehicle when the engine is switched off and the ignition is switched on discharges the vehicle battery. Depending on the vehicle battery charge level, the drop in voltage can be large enough after just a few minutes that electrical consumers in the vehicle will no longer function, e.g. the hazard warning lights.

Additional information and warnings:

Exterior views

Changing gear

Engine management system and exhaust purification system

Starting the engine with jump leads

WARNING

Never tow a vehicle that has no power supply.

Never remove the key from the ignition. Otherwise the steering column lock could engage suddenly. You will no longer be able to steer the vehicle. This can lead to a loss of control of the vehicle, accidents and serious injuries.

If the power supply to the towed vehicle is disconnected, stop towing immediately and seek expert assistance.

WARNING

If a vehicle is being towed, the vehicle handling and braking effect will change significantly. Please note the following in order to reduce the risk of an accident or serious injuries:

Notes for the driver of the towed vehicle:
- You will need to depress the brake pedal more vigorously than normal as the brake servo is not working. Always be careful not to drive into the vehicle that is pulling your vehicle.
- You will need to turn the steering wheel more vigorously as the power-assisted steering function is not working.

Notes for the driver of the towing vehicle
- Accelerate carefully and gently.
- Avoid sudden braking and driving manoeuvres.
- Brake earlier than normal by pressing lightly on the brake pedal.

NOTICE

Remove and install the cover and the towing eye carefully so as to avoid damage to the vehicle, e.g. the paintwork.

Unburnt fuel can enter the catalytic converter and damage it while the vehicle is being towed.

Tow-starting and towing

...

Notes on tow-starting

First read and observe the introductory information and safety warnings Vehicles should not be tow-started wherever possible. Use jump leads to start the engine instead . For technical reasons, ...

Other materials:

Special Connector Systems
Note If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to → Chapter „Secondary Lock“. ...

Single Wire Seal Assembly Tools
Assembly tools serve the purpose of allowing the single wire seals to be slid without damage into terminal housing up to stop, this achieves a complete seal between single wire and terminal housing. Four assembly tools for single wire se ...

Various securing systems
Fig. 62 On the rear seats: figure Ⓐ illustrates the main securing points for the child restraint system on the lower retaining rings and top tether. Figure Ⓑ shows how to secure a child restraint system using the vehicle's seat belt First read and observe the introductory information a ...