This chapter contains information on the following subjects:
→ Fuses in the vehicle
→ Changing a blown fuse
At the time of print we are unable to provide an up-to-date overview of the locations of the fuses for the electrical consumers. This is because the vehicle is under constant development, because fuses are assigned differently depending on the vehicle equipment level and because several consumers may use a single fuse. You can get more information about the fuse layout from a Volkswagen dealership.
Several electrical consumers could share a single fuse. Conversely, a single consumer could have more than one fuse.
Therefore fuses should only be replaced when the cause of the fault has been rectified. If a new fuse blows shortly after insertion, have the electrical system checked by a qualified workshop as soon as possible.
Additional information and warnings:
WARNING
High voltages in the electrical system can cause electric shocks, serious burns and death.WARNING
Using unsuitable or repaired fuses and bridging an electrical circuit without fuses can cause a fire and serious injuries.NOTICE
Special Tools
Special tools and workshop equipment
required
Suction Feed Spray Gun -VAG1538-
Stone Chip Tester -VAS5102A-
Paint Thickness Test -VAS5278-
Paint Thickness T ...
Vibration, Causes for Vibration
There are many causes for vibration. Vibration can also be
caused by tire wear, among other things. Tire wear caused by
driving does not always develop evenly over the entire tread.
Due to this, a slight imbalance develops which disturbs the
smoothness o ...
Wheel, Balancing on Stationary Balancing Machine
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...