Volkswagen Polo Owners Manual: Introduction

Volkswagen Polo Owners Manual / Hubcaps / Introduction

This chapter contains information on the following subjects:

→ Wheel cover
→ Wheel bolt caps

Additional information and warnings:

Tyre monitoring system

Cleaning and caring for the vehicle exterior

Vehicle toolkit

Changing a wheel

Breakdown set

WARNING

Using unsuitable hubcaps, or fitting them incorrectly, can cause accidents and serious injuries.

Incorrectly fitted hubcaps can become loose while the vehicle is in motion and endanger other road users.

Do not use damaged hubcaps.

Always ensure that the airflow to cool the brakes is not restricted or reduced. This also applies if hubcaps are retrofitted. If the airflow is not sufficient, the braking distance could increase significantly.

NOTICE

Remove the hubcaps carefully and fit them again properly so as to avoid damage to the vehicle.

Wheel cover

Fig. 163 Removing press-on wheel covers Fig. 164 Removing bolted-on wheel covers First read and observe the introductory information and safety warnings Removing and fitting press-on wheel ...

Other materials:

A/C Refrigerant High Pressure Switch -F23
Note For switching pressures, removing and installing switches and switch arrangement and version, see vehicle-specific refrigerant circuit. Refer to → Rep. Gr.87. ...

Receiver/Dryer
Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the system. Only use tools and materials approved by the manufactu ...

Evacuating and Charging Valve, Low Pressure Side
Special tools and workshop equipment required Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench 1783 - 1/4" Drive Ratchet -VAS6234- WARNING There is a dan ...