Volkswagen Polo Owners Manual: Introduction
This chapter contains information on the following subjects:
→ Indicator lamps
→ Catalytic converter
→ Diesel particulate filter
Additional information and warnings:
- Changing gear
- Filling the tank
- Fuel
- Engine oil
- Battery
- Information stored in the control units
- Tow-starting and towing
WARNING
- Park the vehicle so that no part of the exhaust system can come into contact with any inflammable material underneath the vehicle, e.g. dry grass.
- Never apply underseal or anti-corrosion coatings to the exhaust pipes, catalytic converter, diesel particulate filter or the heat shields on the exhaust system.
Indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Engine management syste ...
Other materials:
High Pressure Sensor -G65
Note
For switching pressures, removing and installing switches
and switch arrangement and version, see vehicle-specific
refrigerant circuit.
Refer to
→ Rep. Gr.87.
...
Tires, Dismounting, Run-Flat Tires and Ultra High Performance Tires
Only trained personnel can perform the assembly work on
run-flat tires and ultra high performance tires.
If equipped check the tire pressure monitoring sensor with
the vehicle diagnostic tester and if necessary replace.
...
Wheel, Mounting, Audi Assembly Instructions
Vehicles with Tire Pressure Monitoring Sensor.
If wheels are changed (for example, change from summer to
winter tires), wheel electronics send data as soon as speed of
new wheels exceeds 25 km/h (15.53 mph). The control module
automatica ...
