This chapter contains information on the following subjects:
→ Warning lamp and coolant temperature display
→ Coolant specification
→ Checking the coolant level and refilling coolant
Never carry out any work on the engine coolant system if you are not familiar with the necessary procedures and if only unsuitable tools as well as incorrect operating equipment and fluids are available ! The work should be carried out by a qualified workshop if you are uncertain. Volkswagen recommends using a Volkswagen dealership for this purpose.
Serious injuries can be caused if work is carried out incorrectly.
Additional information and warnings:

WARNING
Coolant and coolant additives can pollute the environment. Spilt operating fluids must be collected and disposed of properly and with respect for the environment.
Coolant
Warning lamp and coolant temperature displayOverview of the front passenger side
Fig. 9 Overview of the front passenger
side (left-hand drive vehicles). The controls are mirrored in right-hand drive
vehicles
Key for :
Vent
,
Location of front passenger front airbag
in the dash panel
Key-operated switch in the stowage
compartment for switch ...
Discharge Refrigerant Circuit with A/C Service Station
Caution
If it is suspected that chemicals were added to the
refrigerant circuit to seal leaks, do not connect the
A/C service station and do not extract the refrigerant.
...
Electrically Driven A/C Compressor, Flushing
Vehicles with a high voltage system
Observe all of the additional warnings for all work
performed on vehicles with the high voltage system. Refer to
→ Electrical Equipment; Rep. Gr.93.
...