This chapter contains information on the following subjects:
→ Interior mirror
→ Exterior mirrors
For safety reasons it is important that the driver positions the exterior and interior mirrors correctly before starting a journey .
You can use the exterior mirrors and the interior mirror to observe traffic behind you and adjust driving style accordingly. Looking in the exterior mirrors and the interior mirror does not allow the driver to see the entre side and rear area of the vehicle. The area that cannot be seen is known as the blind spot. There may be objects and other road users in the blind spot.
Additional information and warnings:

WARNING

WARNING

NOTICE
Mirrors
Interior mirrorTowing Recognition Control Module -J345
General Information
The Towing Recognition Control Module -J345- recognizes
“trailer mode” when there is a power decrease of at least 5 W
→ Note and transmits this information to various control
modules via the CAN data bu ...
Flat Spots, Correcting
Flat spots cannot be removed from tires with workshop
equipment.
Such flat spots can be "driven out" only by driving the car
until the tires are warm.
We do not recommend the following method during ...
Siemens Wheel Electronics Tire Pressure Monitoring Sensor, Removing and
Installing
WARNING
If tire sealant was used, then the wheel electronics
on that particular wheel must be replaced.
The Siemens wheel electronics does not have a
microencapsulated ...