Fig. 10 Instrument cluster in the dash panel: type 1
Fig. 11 Instrument cluster in the dash panel: type 2
First read and observe the introductory information and safety warningsDescriptions of the instruments or :
Rev. counter (running engine speed in revolutions x 1,000 per minute).
The start of the red zone on the dial indicates the maximum engine speed that may be used in each gear when the engine is warm and after it has been run in properly. You should change up a gear or move the selector lever to D (or lift your foot off the accelerator) before the needle reaches the red zone .
Reset button for the trip recorder display (trip).
NOTICE
Changing up a gear early will help to save fuel and minimise engine noise.
The fuel gauge is located in the lower field of the display or in the speedometer .
1) In some versions of the vehicle, it may be possible to adjust the clock settings using the Settings menu on the instrument cluster display .
Adhesive Surface Pretreatment when Replacing Laser-Soldered Roofs
Dry sand the cataphoretic primer on the roof adhesive surface
-item 6-
→ Item down to the bare metal using P180 sandpaper.
–
Dry sand the roof pillar adhesive surface
...
Tires, Dismounting, Run-Flat Tires and Ultra High Performance Tires
Only trained personnel can perform the assembly work on
run-flat tires and ultra high performance tires.
If equipped check the tire pressure monitoring sensor with
the vehicle diagnostic tester and if necessary replace.
...
Warning and indicator lamp
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Dual clutch gearbox DSG® overheated.
Do not drive on!
Move the selector lever to position P and leave the gearbox
...