Volkswagen Polo Service & Repair Manual: Industrial Dirt Remover
| Industrial Dirt Remover -ABS 600 000 10- |
| Industrial Dirt Remover -ABS 600 000 10- is used to remove
surface rust (metal dust) from the vehicle body. The product is
used undiluted. |
Caution
| The product contains organic and inorganic acids. |
| Protective gloves and glasses must be worn when
handling this product! |
|
 Note
| Before starting to apply, it is necessary to read the safety
measures and advice in the safety data sheet. |
| Even for products which are not required to be labeled by
law, the usual safety measures must be observed for chemical
emissions. |
| During application, observe the following: |
| The temperature of the cleaner and vehicle body must not
exceed 25 °C (77 °F) (do not expose the vehicle and product to
direct sunlight). |
| After washing the vehicle, the product is applied to the
vehicle body using a brush or sponge. Let the product work for
approximately 10 minutes (do not increase the exposure time,
otherwise the paint or plastic parts may corrode). Do not dry
the product. |
| Rinse and wash the body/vehicle with plenty of water. |
| If the vehicle is still not clean after one use, repeat the
cleaning procedure. |
|
|
|
| Chemical composition |
Highly-effective cleaning
combination out of organic and inorganic acids, surface-active agents
and water. |
| Color |
Water-clear,
transparent/clear, colorless fluid |
| pH value |
1 |
| Density at 15 °C (59 °F) |
EN ISO 12185 1.076 ± 0.015 g/ml |
| The guaranteed shelf life of 36 months from date of
manufacture. Use no later than the date indicated on the label
and store in original container at +15 °C to +30 °C (59 ° to 86
°F). |
|
|
|
Definition:
Plastic Cleaner -D 195 850 A1-
Edition 04/2009
Product Description
P ...
Other materials:
Frequently asked questions
If you suspect that there is a fault in the vehicle or if your vehicle has
been damaged, read and observe the following information before
contacting a Volkswagen dealership or qualified workshop. You may also find
useful information in the index under the headings Things to note or Checklist. ...
Changing bulbs in the side turn signals
Fig. 188 Removing the side turn
signal bulb
Fig. 189 Side turn signal:
changing the bulb
First read and observe the introductory
information and safety warnings
Depending on the vehicle, the side turn signal may be located in the front
wing or in the exterior mirror .
Please contact a ...
Siemens Wheel Electronics Tire Pressure Monitoring Sensor, Removing and
Installing
WARNING
If tire sealant was used, then the wheel electronics
on that particular wheel must be replaced.
The Siemens wheel electronics does not have a
microencapsulated ...
© 2016-2026 Copyright www.vwpolo.net
Plastic Cleaner
SprayMax System