First read and observe the introductory information
and safety warnings
Emergency breakaway cable
Always fasten the trailer's emergency breakaway cable properly to the towing vehicle. Leave enough slack in the emergency breakaway cable so that the vehicle can still drive around corners. However, the emergency breakaway cable should not drag along the ground while the vehicle is being driven.
Trailer socket
A 13-pin trailer socket makes the electrical connection between the towing vehicle and the trailer. If the trailer has a 7-pin plug you will need to use an adapter cable.
Rear trailer lights
Ensure that the trailer lights work properly and meet legal requirements. Do not exceed the maximum power consumption for the trailer .
The trailer is connected to the anti-theft alarm:
When the vehicle is locked, the alarm will be triggered as soon as the electrical connection to the trailer is interrupted.
Always switch off the anti-theft alarm when a trailer is being hitched or unhitched. The tilt sensor could otherwise trigger an alarm unnecessarily.
WARNING
NOTICE
HS Spot Thinner
Definition:
HS Spot Thinner -LVM 006 000 A2-
Edition 06/2013
Product Description
HS Spot Thinner -LVM 006 000 A2- is a special drying
accelerator for minor repairs in certain ...
Wire Break with Dual Repair Point
Repair point with intermediate wire section
–
Free up wire intended for repair at two points
(approximately 20 cm to both sides of respective repair points).
–
If required, remove wiring harness wra ...
Checking with Expansion Valve and Receiver/Dryer, with Internally Regulated
A/C Compressor
Note
Connecting service station. Refer to
→ Chapter „Connecting Service Station“.
Observe test requirements. Refer to
→ Chapter „Pressures, Checking“.
–
...