Volkswagen Polo Service & Repair Manual: General Information

Volkswagen Polo Service & Repair Manual / Battery, Starter, Generator, Cruise Control / Battery, Charging / Battery Charger -VAS5906 / General Information

Battery Charger -VAS5906-

WARNING

Risk of injury. Follow all Warnings and Safety Precautions. Refer to → Chapter „Warnings and Safety Precautions“.

WARNING

Batteries that have a light yellow visual indicator do not have to be tested or charged. Jump starting must not be used!

There is a risk of explosion during testing, charging or jump starting.

These batteries must be replaced.

The Battery Charger -VAS5906- was developed especially for charging the vehicle electrical system while the vehicle is on display.

It supplies for automatic charging of 3 - 300 Ah for starter batteries.

The 14.4 V maximum charging voltage is not exceeded. All electrical consumers will be supported up to 30 A by the support charging.

After the battery is completely charged, the Battery Charger -VAS5906- switches to maintenance charging for long-term operation.

The unit starts automatically and does not require any adjustments. Only the charging terminals and the network cable need to be connected.

For more information. Refer to Battery Charger -VAS5906- Operating Instructions.

General Information

Battery Charger -VAS5906

...

Battery, Charging with Battery Charger -VAS5906

WARNING Risk of injury. Follow all Warnings and Safety Precautions. Refer to → Chapter „Warnings and ...

Other materials:

Support Mode with Battery Charger -VAS5095A
General Information The support mode provides the vehicle electrical system with voltage when the battery is removed or disconnected. For more information. Refer to Battery Charger -VAS5095A- Operating Instructions. ...

Safety Precautions
General Safety Precautions As per VBG 20, German industrial liability insurance association. Follow the instructions for the workplace. They should be displayed in the workplace. ...

Corrosion Protection for Body, Attached and Welded Parts
Attachments Coat the insides of the fenders, doors, covers and lids completely. A spray application wet in wet procedure is sufficient. Before assembly, the seal the inside of the attachments with cavit ...