Volkswagen Polo Service & Repair Manual: Flat Connector Systems
 Note
| If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer to
→ Chapter „Secondary Lock“. |
|
|
|
| Flat Connector System with One Retaining Tab |
| – |
Guide the release tool which fits the contact housing into
release channel on contact housing. |
| – |
Grasp contact at wire and push it gently into contact
housing -arrow-. |
Note
| By pushing the contact in the direction of the contact
housing, the contact retaining tab is lifted off the housing
shoulder and can be released using the release tool. |
|
|
|
| – |
At the same time, push release tool in direction of contact
housing and pull the released contact out of contact housing
-arrow-. |
| – |
After removing the contact, release tool can be pulled out
of the contact housing again. |
|
|
|
| Flat Connector System with Two Retaining Tabs |
| – |
Guide the release tool which fits the contact housing into
release channel on contact housing. |
| – |
Grasp contact at wire and push it gently into contact
housing until it stops in direction of
-arrow-. |
Note
| By pushing the contact in the direction of the contact
housing, the contact retaining tabs are lifted off the housing
shoulder and can be released using the release tool. |
|
|
|
| – |
At the same time, push release tool in direction of contact
housing and pull the released contact out of contact housing in
direction of -arrow-. |
| – |
After removing the contact, release tool can be pulled out
of the contact housing again. |
|
|
|
| – |
Guide the release tool which fits the contact housing into
release channel on contact housing. |
| – |
Grasp contact at wire and push it gently into contact
housing -arrow-. |
Note
| By pushing the contact in the direction of the contact
housing, the contact retaining tabs are lifted off the housing
shoulder and can be released using the release tool. |
|
|
|
| – |
At the same time, push release tool in direction of contact
housing and pull the released contact out of contact housing
-arrow-. |
| – |
After removing the contact, release tool can be pulled out
of the contact housing again. |
|
|
|
Note
If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer ...
Note
If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer ...
Other materials:
Two-Part Wash Primer
Definition:
Two-Part Wash Primer -LHV 043 000 A2-
Edition 10/2010
Product Description
The two-part wash primer is a zinc chromate-free,
phenol-free and acid-free two-componen ...
Blender
Definition:
Blender -LLS MAX 009-
Edition 10/2008
Product Description
The Blender -LLS MAX 009- matches the overlapping areas or
the edges from the existing paint to the new ...
Sprayable Sealant
Definition:
Sprayable Sealant -D 476 KD1 M2-, gray
Sprayable Sealant -D 476 KD2 M2-, black
Edition 08/2012
Product Description
Sprayable Sealant -D 476 ...
© 2016-2026 Copyright www.vwpolo.net
Round Connector Systems
Special Connector Systems