IntroductionIntroduction
This chapter contains information on the following subjects:
→ The dangers of assuming an incorrect sitting position
→ Correct sitting position
→ Mechanical controls on the front seats
→ Adjusting the head restraints
→ Removing and fitting head restra ...
Wheel, Balancing on Stationary Balancing Machine
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Contact Release Tools
Various release tools are used to remove the different
terminals from terminal housings without damage.
A selection of release tools are a component of the Wiring
Harness Repair Set -VAS1978- and the Wiring Harness Repair Set
-VAS1978A-. ...