Volkswagen Polo Owners Manual: Fastening and unfastening seat belts

Volkswagen Polo Owners Manual / Sitting correctly and safely / Seat belts / Fastening and unfastening seat belts

Fig. 50 Inserting the seat belt latch plate into the buckle

Fig. 51 Removing the latch plate from the buckle

First read and observe the introductory information and safety warnings

If worn properly, seat belts hold the vehicle occupants in the correct sitting position during an accident or braking manoeuvre, providing maximum protection .

Fastening the seat belts

Fasten seat belts before every trip.

Always adjust the front seat and head restraint correctly .

Engage the rear seat backrests in an upright position .

Take hold of the latch plate and pull it evenly across your chest and pelvis. Do not twist the belt in the process .

Insert the latch plate securely into the buckle belonging to the occupied seat .

Pull on the seat belt to ensure that the latch plate is securely locked in the buckle.

Unfastening the seat belts

Unfasten seat belts only when the vehicle is stationary .

Press the red button in the buckle . The latch plate is released and springs out.

Guide the belt back by hand so that it rolls up easily, without twisting the seat belt and without damaging the trim.

WARNING

Incorrect seat belt routing can cause severe or fatal injuries in the event of an accident.

The seat belts only offer best protection when the backrests are in an upright position and the seat belts have been fastened properly according to the occupant's height.

Unfastening seat belts while the vehicle is in motion can lead to severe or fatal injuries in the event of an accident or sudden braking manoeuvre.

Checklist

Using seat belts : Check the condition of all seat belts regularly. Keep the seat belts clean. Avoid allowing any foreign bodies or fluids to get on to the seat belt or latch plate o ...

Seat belt routing

Fig. 52 Correct seat belt routing and head restraint adjustment Fig. 53 Correct seat belt routing during pregnancy First read and observe the introductory information and safety warnings Se ...

Other materials:

Instrument overview
Fig. 10 Instrument cluster in the dash panel: type 1 Fig. 11 Instrument cluster in the dash panel: type 2 First read and observe the introductory information and safety warnings Descriptions of the instruments or : Rev. counter (running engine speed in revolutions x 1,000 per mi ...

Round Connector Systems
Note If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to → Chapter „Secondary Lock“. ...

Reservoir
Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the system. Only use tools and materials approved by the manufactu ...