Volkswagen Polo Service & Repair Manual: Extraction and Charging System Safety Regulations
| Make sure the shut-off valves are closed before connecting
the charging system to the air conditioning system. |
| Make sure the process is finished before disconnecting the
charging system from the A/C system. This prevents any
refrigerant from escaping into the atmosphere. |
| Once the purified refrigerant from the charging system has
been transferred to an external compressed-gas cylinder, close
the hand shut-off valves at the cylinder and charging system. |
| Do not expose charging system to moisture or use it in a wet
environment. |
| Disconnect from power supply before performing service work
on the charging system. |
| Never use an extension cable on account of the fire hazard.
If the use of an extension cable is unavoidable, the minimum
cross-section should be 2.5 mm2.
|
| In case of fire, remove the external cylinder. |
| Entrained oil from the air conditioning system drawn by the
suction unit into the measurement vessel supplied is
subsequently to be transferred to a sealed container as it
contains a small quantity of refrigerant. It must not be
released into the environment. |
| Following shutdown, A/C service station is to be secured to
stop it rolling away. |
|
|
|
Secure vessels to prevent them falling over!
Secure upright cylinders to stop them falling over and
cylinders lying flat to stop them rolling away.
...
A/C Service Station -VAS6007A- (and further or current A/C
Service Station)
Refer to the Workshop Equipment Catalog.
...
Other materials:
Tires, Mounting, Wheels without and with Tire Pressure Monitoring System
Only trained personnel can perform the assembly work on
run-flat tires.
If equipped check the tire pressure monitoring sensor with
the vehicle diagnostic tester and if necessary replace.
–
Bring the t ...
Cleaning and caring for chrome and aluminium trim parts
First read and observe the introductory information
and safety warnings
Use a damp, clean, lint-free and soft cloth to clean the surfaces.
For heavy soiling use a special solvent-free cleaning product.
Polish the chrome and aluminium trim parts using a soft, dry cloth.
NOTICE
...
Checklist
The following actions must always be carried out in the given
order in preparation for changing the wheel :
In the event of a flat tyre, park
your vehicle on a firm and level surface at a safe distance from the flow of
traffic.
Apply the handbrake firmly Braking,
stopping an ...
© 2016-2026 Copyright www.vwpolo.net
