VW Polo manuals

Volkswagen Polo Service & Repair Manual: Evacuating and Charging Valve with Schrader Valve

Special tools and workshop equipment required
Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench 1783 - 1/4" Drive Ratchet -VAS6234-
  WARNING
There is a danger of ice-up.
Refrigerant will leak out if refrigerant circuit is not discharged.
Refrigerant must be extracted before opening refrigerant circuit. If refrigerant circuit is not opened within 10 minutes of extraction, pressure may form in refrigerant circuit due to evaporation. Extract the refrigerant once more.
Only valves and connections that are resistant to refrigerant R134a and refrigerant oil must be installed.
Different connections (outer diameter) for high pressure and low pressure side.
Always screw on sealing caps.
Allocation in vehicle.
   
Refer to → Rep. Gr.87 for the vehicle-specific repair manual.
  Note
Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench 1783 - 1/4" Drive Ratchet -VAS6234-
Use a suitable Refrigerant Sockets -T10364- to loosen the Schrader valve insert. Refer to → Fig. „“ Refrigerant Sockets -T10364- for the high pressure/low pressure side service connection valves in the refrigerant circuit”“
A -  Service connection (soldered in)
B -  Schrader valve insert (2.4 ± 0.2 Nm)
C -  O-ring (belongs to the valve)
D -  Sealing cap with seal
 

Evacuating and Charging Valve with Schrader Valve

Refrigerant Circuit Extraction and Filling Valves for Service Station Couplings
...

Evacuating and Charging Valve, High Pressure Side
Special tools and workshop equipment required Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench 1783 - 1/4" Drive Ratchet -VA ...

Other materials:

Using the cruise control system
Fig. 123 On the left of the steering column: button and switch for the CCS First read and observe the introductory information and safety warnings  Function Switch position, switch control   Action Switching on the CCS. Switch ② i ...

Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
Before beginning balancing, the following requirements must be fulfilled. The tire pressure must be OK. The tire profile must not be worn on one side. The tire profile must be at least 4 mm. ...

Two-Part Fine Filling Paste
Definition: Two-Part Fine Filling Paste -LSP 784 002 A2- Edition 06/2011 Product Description The two-part fine filling paste is a very fine thixotropic polyester filling past ...

© 2016-2026 Copyright www.vwpolo.net