Volkswagen Polo Service & Repair Manual: Decorative Trims, Replacing, Bonded Decorative Trims
| Special tools and workshop equipment
required |
| Trim Removal Wedge -3409- |
| Wiring Harness Repair Set - Hot Air Blower -VAS1978/14A- |
|
|
|
|
|
- DH 009 100 A2- |
|
|
- LSE 020 100 A3- |
| Decorative Trim, Removing |
Note
| It is not possible remove the decorative trim without damaging it. |
| – |
Loosen the lock washers -2- from the
inside of the light alloy wheel. |
| – |
Warm the decorative trim -1- from the
outside using the Hot Air Blower -VAG1416-. |
 Caution
| Do not overheat tires and light alloy wheels. |
|
| – |
Loosen the decorative trim -1- from the
inside of the light alloy wheel using the Trim Removal Wedge -3409-. |
| – |
Grab under one corner from the outside and pull the decorative trim
-1- off the light alloy wheel. |
Note
| The adhesive points for the PUR label are cut into the light alloy
wheel. |
| The remaining material serves as the adhesive base for the new
decorative trim. |
| The new decorative trim can be installed immediately. |
| Decorative Trim, Installing |
| These light alloy wheels are equipped with replaceable decoration
elements. Note the following when installing. |
| Make sure the adhesion area on the light alloy wheels and decorative
trim are free of dust and grease. |
| Clean the adhesion area with Silicone Remover -LSE 020 100 A3-. |
| – |
Apply 1K Window Adhesive -DH 009 100 A2- on the adhesive surfaces
-arrows- using the Cartridge Gun -VAG1628-. |
| Adhesive point: length = approximately 25 mm and diameter =
approximately 10 mm |
| – |
Press the decorative trim -2- into the
light alloy wheels -1- using firm pressure. |
| – |
Secure the decorative trim -2- to the
inside of the light alloy wheel with lock washers
-3-. |
| Minimum Curing Time: 3 Hours at Room Temperature of Minimum 15 °C
(59 °F). |
 WARNING
| The light alloy wheel must be balanced again. Refer to
→ Chapter „Vibration“. |
|
These disc wheels are equipped with replaceable decoration
elements. Note the following when installing.
–& ...
Other materials:
Stopping the engine
First read and observe the introductory information
and safety warnings
The steps should only be carried out in the specified order.
1.
The vehicle must be completely stationary .
2.
Press the brake pedal. Keep ...
Securing child seats with the top tether
Fig. 65 Retaining ring for top tether
in the stowage area behind the rear seats
Fig. 66 Top tether hooked over into the
luggage compartment
First read and observe the introductory information
and safety warnings
Observe the child seat manufacturer's instructions when fitting or removin ...
What happens to vehicle occupants who have not fastened their seat belts
Fig. 47 An unbelted driver is thrown forwards
Fig. 48 The unbelted rear passenger is
thrown forwards, hitting the belted driver
First read and observe the introductory information
and safety warnings
Many people believe that they can brace their weight with their hands in a minor
collisi ...
© 2016-2024 Copyright www.vwpolo.net
Decorative Trims, Replacing, Bolted Decorative Trims