Volkswagen Polo Owners Manual: Contents
Fig. 162 Contents of the vehicle toolkit
First read and observe the introductory
information and safety warnings
The content of the vehicle toolkit depends on the vehicle equipment level. The following describes the maximum scope.
The vehicle toolkit contains the following
Screwdriver with hexagon socket in
the handle for slackened wheel bolts. The screwdriver blade (Torx) is
reversible.
Adapter for the anti-theft wheel
bolts. Volkswagen recommends that you carry the wheel bolt adapter in the
vehicle toolkit at all times. The code number of the
anti-theft wheel bolt is stamped on the front of the adapter. You will need
this number to replace the adapter if lost. Make a note of the code number
for the anti-theft wheel bolt and keep it in a safe place – but not inside
the vehicle. 
Removable towing eye. 
Wire hook for pulling off the wheel
covers and wheel bolt caps. 
Vehicle jack. Before you return the
vehicle jack to the toolbox, fully wind in the claw. To stow the vehicle
jack securely the crank lever must be braced against the side of the jack. 
Box spanner for wheel bolts.
Stowage
Fig. 161 In the luggage
compartment underneath the floor covering A: Spare wheel and vehicle toolkit
without ball coupling, B: Spare wheel and vehicle toolkit with ball coupling, C:
Spare wheel ...
Hubcaps
...
Other materials:
Battery Charger -VAS5903- Maintenance Charging
Note
If the battery is discharged by an electrical consumer
during maintenance charging, the Battery Charger -VAS5903-
automatically supplies the appropriate charge.
Maintenance charging can be performed without time ...
Performance figures
First read and observe the introductory information
and safety warnings
For reasons of vehicle registration and vehicle taxation, the power output and
performance of some engines may vary in some countries from the information given
in this booklet.
Petrol engines
...
Secondary Lock
The secondary lock is a housing securing mechanism (second
locking mechanism) that secures all wires in one contact
housing. If a secondary lock is installed at a contact housing,
it must always be opened or removed using specified tool before
releasing ...
