VW Polo manuals

Volkswagen Polo Service & Repair Manual: Contact Housings, Repairing Wire Terminals

  Note
   
For technical reasons, the contact housing for the wire terminals can be supplied only with the contacts pushed in.
These contacts can be removed at every other contact housing in the event they are not required.
Repair wires which have already been equipped with corresponding contacts crimped on are available. Refer to Parts Catalog.
 

Contact Housings, Repairing Wire Terminals

Single Wire Seals, Installing
  Note Single wire seals prevent the penetration of water and dirt into the contact housing. They are installed, for example, in the engine compart ...

Contact Housings, Releasing and Disassembling
...

Other materials:

Valve, Removing and Installing, Metal Valve
Special tools and workshop equipment required Torque Wrench -VAG1410- Perform the Following: Removing –  Remove the Tire Pressure Monitoring Sensor. Refer to ...

Taper
Taper is caused by slightly offsetting the tread and/or the belt by a few tenths of a millimeter from the geometric center of the tire. Taper cannot be recognized visually nor can it be measured with workshop equipment.     ...

Vehicle Diagnostic Tester, Connecting, Golf MY 1998 through 2003
  Apply the parking brake. –  In vehicles with automatic transmission, move the selector lever to the “P” or “N” position. –  In vehicles with manual transmissions, move the shift l ...

© 2016-2026 Copyright www.vwpolo.net