Volkswagen Polo Service & Repair Manual: Contact Housings, Releasing and Disassembling
- Releasing and Disassembly Contact Housings, General Information
- Secondary Lock
- Primary Lock
- Round Connector Systems
- Flat Connector Systems
- Special Connector Systems
Contact Housings, Repairing Wire Terminals
Note
For technical reasons, the contact housing for the wire
terminals can be supplied only with the contacts p ...
Releasing and Disassembly Contact Housings, General Information
Note
Observe general notes for repairs on the vehicle electrical
system. Refer to
→ Chapter „Vehicle Electrical System, General Repa ...
Other materials:
Taper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...
Wheel Balancing, Rim Radial and Lateral Run-Out, Checking
Mount the rim on the Balancing Machine.
–
Use the Wheel Centering System Adapter -VAS5271-.
–
Preload the Tire Dial Gauge approximately 2 mm.
–
Turn the rim slowly.
...
Tires, Bringing to Mounting Temperature
Caution
There is a risk of damaging tires with strong heat.
Never heat the tires with a heater or a hot air gun.
Warm tires with warm water or warm ...
