Volkswagen Polo Owners Manual: Checklist

Volkswagen Polo Owners Manual / Sitting correctly and safely / Seat belts / Checklist

Using seat belts :

Check the condition of all seat belts regularly.
Keep the seat belts clean.
Avoid allowing any foreign bodies or fluids to get on to the seat belt or latch plate or into the slot for the seat belt buckle.
Do not trap or damage the seat belt and latch plate, for example when closing the door.
Never remove, modify or repair the seat belt or any part of the belt fixture system.
Always fasten the seat belt correctly before every journey and keep it fastened while the vehicle is in motion.

Twisted seat belt

If it is difficult to remove the seat belt from the belt guide, the seat belt may have become twisted if it was returned too quickly into the side trim:

Take hold of the latch plate then slowly and carefully pull out the seat belt.

Untwist the seat belt and guide it back slowly by hand.

Fasten the seat belt even if you are unable to undo the twist. However, the twist should not be in part of the seat belt that comes into direct contact with the body. The twist should be corrected immediately by a qualified workshop.

WARNING

Using seat belts incorrectly increases the risk of severe or fatal injuries.

Regularly check to see if the seat belt and its related parts are in perfect condition.

Always keep the seat belt clean.

Do not allow the belt webbing to become jammed, damaged or to rub on any sharp edges.

Always keep the latch plate and slot in the buckle free from foreign bodies and liquids.

Using seat belts

First read and observe the introductory information and safety warnings ...

Fastening and unfastening seat belts

Fig. 50 Inserting the seat belt latch plate into the buckle Fig. 51 Removing the latch plate from the buckle First read and observe the introductory information and safety warnings If worn ...

Other materials:

New wheels and tyres
First read and observe the introductory information and safety warningsNew tyres Drive particularly carefully for the first 600 km with new tyres as the tyres have to be run in. Tyres that have not been run in have reduced grip and braking effect . All four wheels must be fitted ...

Warning lamp and coolant temperature display
Fig. 138 Coolant temperature display in instrument cluster: Ⓐ cold; Ⓑ normal; Ⓒ warning First read and observe the introductory information and safety warningsA display for the coolant temperature may be, depending on the vehicle equipment, located in instrument cluster. In normal driv ...

Contents of the breakdown set
Fig. 171 The breakdown set First read and observe the introductory information and safety warnings The breakdown set is located underneath the floor covering in the luggage compartment. It includes the following components : Valve core extractor Sticker with the maximum permitted s ...