Fig. 184 On the side of the luggage compartment: removing the tail light cluster
Fig. 185 Tail light cluster: removing the bulb holder
First read and observe the introductory information and safety warningsThe steps should only be carried out in the specified order.
Removing the tail light cluster
1. | Follow the instructions on the checklist . |
2. | Open the tailgate . |
3. | Turn the sash fastener (arrow) in the side trim of the luggage compartment to the side. |
4. | Hold the sash fastener and pull out the pre-cut cover in the side trim. |
5. | Push together the catches on the connector and pull out the connector. |
6. | Unscrew the securing bolts by hand . |
7. | Carefully pull the tail light cluster to the rear to remove it from the body. Place it on a clean, smooth surface. |
Changing the bulb
7. | To release the bulb holder, push the tabs and ② in the direction of the arrows. |
8. | Remove the bulb holder from the tail light cluster. |
9. | Replace the defective bulb with a new bulb of the same type. |
10. | Insert the bulb holder into the tail light cluster. All release tabs must click into place. |
Fitting the tail light cluster
11. | Carefully put the tail light cluster into the opening in the body. |
12. | Use one hand to hold the tail light cluster in the fitting position while using the other hand to screw the securing bolt firmly back on . |
13. | Check that the tail light cluster is positioned correctly and securely. |
14. | Connect the connector to the bulb holder until it engages. |
15. | Fit the side trim back into the luggage compartment. |
16. | Close the tailgate . |
Run-Flat System PAX, Dimensions and Designations on PAX Rims
Example: 235 x 500 A - 5 - 41
235 -
Designated width in millimeters
x -
One-part
500 -
Designated diameter of standardized rim seat in millimeters
...
Single Wire Seal Assembly Tools
Assembly tools serve the purpose of allowing the single wire
seals to be slid without damage into terminal housing up to
stop, this achieves a complete seal between single wire and
terminal housing.
Four assembly tools for single wire se ...
Towing a trailer
First read and observe the introductory information
and safety warnings
Headlight adjustment
Towing a trailer can raise the front end of the vehicle enough for the dipped
beam to blind other road users. Use the headlight range control to lower the light
cone as required. If you do not have ...