VW Polo manuals

Volkswagen Polo Owners Manual: Changing a bulb

Changing a blown fuse
Fig. 174 A blown fuse Fig. 175 Removing or fitting a fuse using the plastic pliers ① First read and observe the introductory information and safety warnings Preparation Switch off the ...

Introduction
This chapter contains information on the following subjects:  → Indicator lamp  → Information on changing bulbs  → Removing and installing the headlights  → Changing ...

Other materials:

Evacuating and Charging Valve, High Pressure Side
Special tools and workshop equipment required Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench 1783 - 1/4" Drive Ratchet -VAS6234-   WARNING There is a dan ...

Indicator lamps
First read and observe the introductory information and safety warnings Lit up Possible cause Solution Engine management system fault (Electronic Power Control). The engine should be checked by a qualified workshop as s ...

7-Pin« Trailer Socket
If more electrical consumers need to be connected than the »7-pin« socket allows, a second »7-pin« socket must be installed. Pin assignment must conform to DIN ISO 1724: 1 - Left turn signal 2 - Tail ...

© 2016-2026 Copyright www.vwpolo.net