Volkswagen Polo Owners Manual: Catalytic converter
First read and observe the introductory information
and safety warnings
The catalytic converter is used for exhaust gas post-treatment and helps to reduce exhaust emissions. To help ensure long-term functionality in the exhaust system and the catalytic converter:
- Use unleaded petrol only.
- Do not allow the fuel tank to run empty.
- Do not overfill engine oil .
- Do not tow-start the vehicle. Use jump leads .
If you notice misfiring, uneven running or loss of power when the vehicle is moving, reduce speed immediately. The vehicle should be inspected at the nearest qualified workshop. If this happens, unburnt fuel can enter the exhaust system and escape into the atmosphere. The catalytic converter can also be damaged by overheating.
Even when the exhaust purification system is working perfectly, there may be a smell of sulphur from the exhaust in some conditions. This depends on the sulphur content of the fuel being used.
Indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Engine management syste ...
Diesel particulate filter
First read and observe the introductory information
and safety warningsThe diesel particulate filter filters out soot particles
in the exhaust gas. The soot particles gather in the filter and are ...
Other materials:
Using a mobile telephone in the vehicle without a connection to the external
aerial
First read and observe the introductory information
and safety warningsBoth during telephone calls and in standby mode, mobile
telephones transmit and receive radio waves, which may also be termed "high-frequency
energy". Current scientific literature warns us that radio waves can be harmful
...
Introduction
This chapter contains information on the following subjects:
→ Indicator lamps
→ Start/stop system
→ Hill Hold Assist
Additional information and warnings:
Volkswagen information system
Braking, stopping and parking
Battery
Wh ...
Flat Connector Systems
Note
If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer to
→ Chapter „Secondary Lock“.
...
