Volkswagen Polo Service & Repair Manual: Beru Wheel Electronics Tire Pressure Monitoring Sensor, Removing and
Installing
– |
Push the wheel electronics -1-
into the bed.
|
– |
Install on the valve from the back with a microencapsulated
screw -item 8-
→ Item |
Note
Replace the microencapsulated screw. |
Tighten the microencapsulated screw to 4 Nm on all models. |
Special tools and workshop equipment
required |
Torque Wrench 1410 -VAG1410- and Torque Wrench 1410 Insert -
Accessory Kit -VAG1410/1- |
Tightening Specifications. Refer to
→ Anchor. |
|
|
|
Special tools and workshop equipment
required
Torque Wrench 1410 -VAG1410- and Torque Wrench 1331 5-50Nm
-VAG1331-
...
WARNING
If tire sealant was used, then the wheel electronics
on that particular wheel must be replaced.
...
Other materials:
Indicator lamps
Fig. 55 In the upper section of the centre
console: indicator lamp for disabled front passenger front airbag
First read and observe the introductory information
and safety warnings
Lit up
Location
Possible cause
Solution
Instrument c ...
Acoustic and optical ParkPilot signals at the rear of the vehicle
Fig. 121 ParkPilot screen display (colour)
Fig. 122 ParkPilot screen display (monochrome)
First read and observe the introductory information
and safety warnings
Key for displays
and
Meaning
Ⓐ
Scanned area ...
Introduction
This chapter contains information on the following subjects:
→ services
→ Applications (apps)
Information on the mobile online services Car-Net and applications (apps) can
be transmitted directly to your vehicle and integrated.
Information on Car-Net services and application ...
© 2016-2024 Copyright www.vwpolo.net