Volkswagen Polo Service & Repair Manual: Battery, Charging with Battery Charger -VAS5906

Volkswagen Polo Service & Repair Manual / Battery, Starter, Generator, Cruise Control / Battery, Charging / Battery Charger -VAS5906 / Battery, Charging with Battery Charger -VAS5906

WARNING

Risk of injury. Follow all Warnings and Safety Precautions. Refer to → Chapter „Warnings and Safety Precautions“.

WARNING

Batteries that have a light yellow visual indicator do not have to be tested or charged. Jump starting must not be used!

There is a risk of explosion during testing, charging or jump starting.

These batteries must be replaced.

Control Panel Overview

1 -	25% charge display.

2 -	50% charge display.

3 -	75% charge display.

4 -	100% charge display.

5 -	Ready-to-use display

6 -	Pushing the start/stop and setup buttons will stop and start the charging process. Enter into the setup menu and select characteristic line type (hold for 10 seconds)

7 -	Display malfunction

–	Position the battery charger inside the engine compartment or under the vehicle.

–	Connect the network cable to the battery charger and then connect it to the network.

When the battery charger is in idle - the ready-to-use lights up.

WARNING

Risk of injury. Follow all Warnings and Safety Precautions. Refer to → Chapter „Warnings and Safety Precautions“.

–	Turn off the ignition.

–	Connect the red charger cable to the positive terminal “+” on the battery.

Note

In the case of vehicles with a start/stop function and an installed Battery Monitoring Control Module -J367-, the black charging clamp (-) must be connected to the body ground. The start/stop system will malfunction if it is connected to the negative terminal on the battery.

–	Connect the black charge cable to the negative terminal “-” on the battery.

Charging will begin after approximately 2 seconds.

LEDs show the battery charge level. When all the lamps illuminate, the battery is charged.

When the battery is completely charged, the Battery Charger -VAS5906- automatically switches to maintenance charging.

Caution

Sparks can result if the charging terminals are removed too early. Press the stop/start button to end the charging process.

–	Press the start/stop button to end the charging.

–	Disconnect the black charging cable from the negative terminal “-” on the battery.

–	Disconnect the red charging cable from the positive terminal “+” on the battery.

Battery, Charging with Battery Charger -VAS5906

General Information

Battery Charger -VAS5906- WARNING Risk of injury. Follow all Warnings and Safety Precautions. Refer ...

Battery Tester Charger Kit -GRX3000VAS

...

Other materials:

Wiring Harness Repair Set -VAS1978
The Wiring Harness Repair Set -VAS1978- makes optimal repair quality possible in the realm of vehicle electronics. Using the tools, repairs affecting harness connectors and for breaks in wiring can be performed. For this purpose, complete repair wires wi ...

Wax Spray -D 322 100 M2
Definition: Wax Spray -D 322 100 M2- Edition 01/2011 Product Description Wax Spray -D 322 100 M2- is a long-term anti-corrosion agent. After drying, the product forms a light ...

Introduction
This chapter contains information on the following subjects: → Indicator lamp → Using the cruise control system The cruise control system (CCS) helps to maintain an individual set speed at forward speeds of approx. 20 km/h (12 mph) and higher. The CCS only slows the veh ...