Volkswagen Polo Service & Repair Manual: Battery, Charging with Battery Charger -VAS5095A
| Special tools and workshop equipment
required |
| Battery Charger -VAS5095A- |
WARNING
| Risk of injury. Follow all Warnings and Safety
Precautions. Refer to
→ Chapter „Warnings and Safety Precautions“. |
|
Caution
| While charging, always set the battery type to 2.4
V/C (Volts/Battery Cell)! This applies to all batteries. |
|
 Note
| The battery temperature must be at least 10 °C (50 °F). |
WARNING
| Batteries that have a light yellow visual indicator
do not have to be tested or charged. Jump starting must
not be used! |
| There is a risk of explosion during testing,
charging or jump starting. |
| These batteries must be replaced. |
|
| – |
Turn off the ignition and all electrical consumers. |
| – |
Check the battery type setting on the battery type selector.
Refer to
→ Chapter „Battery Charger -VAS5095A- Device Description“.
It must be set to 2.4V/C (Volts/Cell). |
| – |
Clamp the red charging clamp “+” of the charger to the
positive battery terminal. |
Note
| In the case of vehicles with a start/stop function and an
installed Battery Monitoring Control Module -J367-, the black
charging clamp “-” must be connected to the body ground. The
start/stop system will malfunction if it is connected to the
negative terminal on the battery. |
| – |
Connect the black charging clamp “-” of the charger to the
negative battery terminal. |
| – |
Switch on the battery charger. Refer to
→ Chapter „Battery Charger -VAS5095A- Device Description“. |
| Charge current displays. Refer to
→ Fig. „“Battery Charger -VAS5095A- ”“-2-
and -3- light up yellow. When only
the yellow LED -3- is lit, the
battery is partially charged (approximately 90%). |
| If the green LED. Refer to
→ Fig. „“Battery Charger -VAS5095A- ”“-4-
is also lit, the charger has switched to the charge sustain
function. The battery is charged. |
| – |
Switch off the charger. Refer to
→ Chapter „Battery Charger -VAS5095A- Device Description“. |
| – |
Remove the charger clamps from the battery terminals. |
|
|
|
WARNING
Risk of injury. Follow all Warnings and Safety
Precautions. Refer to
→ Chapter „Warnings and ...
WARNING
Risk of injury. Follow all Warnings and Safety
Precautions. Refer to
→ Chapter „Warnings and ...
Other materials:
Declaration of conformity
First read and observe the introductory information
and safety warningsThe individual manufacturer declares herewith that the
following products conform, at the time of vehicle production, with the basic requirements
and other relevant laws and regulations, including FCC Part 15.19, FCC Part 1 ...
Stone Chip Tester -VAS5102A
Definition:
Stone Chip Tester -VAS5102A-
Product Description
The Stone Chip Tester -VAS5102A- is a proprietary tool of
Volkswagen AG. It can identify whether chipped paint is the
result of a ...
Parking Aid Sensor, Painting
The following parameters must be met when painting to avoid
malfunctions in the parking aid sensor (parking aid system):
New Part, Painting
Maximum coat thickness 125 µm; the coat thickness must
always be measured ...
© 2016-2026 Copyright www.vwpolo.net
Battery Charger -VAS5095A- Device Description
Severely Discharged Battery, Charging with Battery Charger -VAS5095A