IntroductionWheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Tire Pressure Sensor and Metal Valve, Removing and Installing
Special tools and workshop equipment
required
Torque Wrench 1410 -VAG1410- and Torque Wrench 1331 5-50Nm
-VAG1331-
–
Place metal valve with rubber seal through rim from inside.
...
Inspecting Tires
Because tire damage can have serious consequences, the
technician and the driver should regularly check the tires, as
it is the best form of early problem recognition.
Pre-damaged tires cannot withstand driving situations like
high vehic ...