Volkswagen Polo Service & Repair Manual: ACC - Adaptive Cruise Control

Volkswagen Polo Service & Repair Manual / General Paint Information / General Information / ACC - Adaptive Cruise Control

Note

On vehicles with ACC, the trim in the right cover section of the front bumper must not be painted if paint repairs or component replacements are performed. The ACC system is located behind this section therefore a coat of paint would destroy its functionality.

The cover for the distance regulation sensor in the bumper grille is composed of radar-penetrable material. The cover is heated to avoid functions being restricted from snow or ice.

All changes to the surface such as additional painting, bonding and other supplementary applied objects can cause malfunctions.

Distance Regulation Control Module -J428-

The image shows the Distance Regulation Control Module - J428- on the Golf. The image can vary on other vehicle models.

1 -	Adapter Plate

2 -

Bracket

3 -	Fastening Hole

4 -	Vertical Adjustment Bolt

5 -

Trim

6 -	Distance Regulation Sensor/ Distance Regulation Control Module

7 -	Horizontal Adjustment Bolt

ACC - Adaptive Cruise Control

Parking Aid Sensor, Painting

The following parameters must be met when painting to avoid malfunctions in the parking aid sensor (parking aid system): New Part, Painting ...

Original Products

Paint Products in Service Note For guarantee and warranty work, Volkswagen AG advises to use only original Volkswagen products or pain ...

Other materials:

Restrictor
Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the system. Only use tools and materials approved by the manufactu ...

Introduction
This chapter contains information on the following subjects: → Warning lamp → Frontal collisions and the laws of physics → What happens to vehicle occupants who have not fastened their seat belts → Seat belt protection → Using seat belts → ...

Cigarette Lighter Illumination Bulb -L28-, Removing and Installing
Note On some vehicle equipment levels, socket illumination is via Light Emitting Diode (LED) instead of a bulb. These LEDs are integrated with the illumination housing and cannot be serviced or replaced separately. ...