Volkswagen Polo Service & Repair Manual: A/C Refrigerant Low Pressure Switch -F73
 Note
| For switching pressures, removing and installing switches
and switch arrangement and version, see vehicle-specific
refrigerant circuit. |
|
|
|
| Switches off A/C compressor when there is excessive pressure
in the refrigerant circuit (approximately 2 bar (29 psi)). |
|
|
|
Note
For switching pressures, removing and installing switches
and switch arrangement and version, see vehicle-specific
refrigerant circuit.
...
Note
For switching pressures, removing and installing switches
and switch arrangement and version, see vehicle-specific
refrigerant circuit.
...
Other materials:
Two-Part HS Wet-in-Wet Filler
Definition:
Two-Part HS Wet-in-Wet Filler -LVM 013 008 A4-, light gray
Two-Part HS Wet-in-Wet Filler -LVM 013 905 A4-, black
Edition 03/2015
Product Description
...
Information on the brakes
First read and observe the introductory information
and safety warnings New brake pads cannot generate
the full braking effect during the first 200 to 300 km and must first be run in
. However, you can compensate for the slightly reduced braking force
by applying more pressure to the bra ...
Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
© 2016-2026 Copyright www.vwpolo.net
Magnetic Clutch High Pressure Switch -F118
Refrigerant Circuit Connections with Valve for Switches