Volkswagen Polo Service & Repair Manual: 13-Pin« Trailer Socket
| The backup lamps, »continuous current«
and charging cable can be used on the trailer with the
»13-pin« trailer socket. A
»13-pin« trailer socket is
recommended if a bicycle rack will be installed or a camper will
be towed. |
|
|
|
| Pin assignment must conform to DIN ISO 11446: |
| 3 - Ground for circuit 1 through 8 |
| 9 - Terminal 30 (permanent positive) |
| 10 - Terminal 15 (battery charging in trailer) |
| 13 - Terminal 15/30 ground |
|
|
|
If more electrical consumers need to be connected than the
»7-pin« socket allows, a second
»7-pin« socket must be installed.
Pin assignment must conform to DI ...
General Information
The Towing Recognition Control Module -J345- recognizes
“trailer mode” when there is a power decrease of at least 5 W
& ...
Other materials:
AGM Battery, Checking
Perform Battery Checks in the Following Sequence:
1.
Visual inspection. Refer to
→ Chapter „Visual Inspection“.
2.
Check the battery using the Battery Tester -VAS6161-. Refer
to
...
Special Connector Systems
Note
If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer to
→ Chapter „Secondary Lock“.
...
Wire Break with Dual Repair Point
Repair point with intermediate wire section
–
Free up wire intended for repair at two points
(approximately 20 cm to both sides of respective repair points).
–
If required, remove wiring harness wra ...
© 2016-2026 Copyright www.vwpolo.net
7-Pin« Trailer Socket
Towing Recognition Control Module -J345