Volkswagen Polo Service & Repair Manual: Tires, Dismounting
Note
| If equipped handle the glued-on wheel trim carefully.
Surface slightly scratched. |
| Replace the damaged rim wheel trim. |
|
|
|
| – |
Place the press-off blade -1-
over the tire valve -arrow- and
maximum 2 cm away from rim flange. |
| – |
Remove the balance weight and any dirt from the rim. |
|
|
|
| – |
Press off both tire beads all the way around and thoroughly
apply tire mounting paste between the tire and rim flange
-arrow-. |
Note
| Avoid strong braking or acceleration maneuvers during the
first 100 to 200 km. Otherwise due to the tire mounting paste
the tires can distort on the rim. |
|
|
|
Place the wheel on a flat surface.
–
Remove the valve insert.
Caution
...
Other materials:
EU Tire Label, Categories
Rolling Resistance. Refer to
→ Anchor
Wet Grip. Refer to
→ Anchor
Noise Emission. Refer to
→ Anchor
Rolling Resistance ...
Oxygen Sensor Unit Protective Pipes
Note
In addition to using the part number, the protective pipe
can also be used for identification.
Version D1, 6 openings, 3.5 mm each
Only used with the 4-pin oxygen sen ...
Coolant specification
First read and observe the introductory information
and safety warningsThe cooling system is filled at the factory with a mixture
of specially prepared water and at least 40% coolant additive G 13
(TL-VW 774 J). The coolant additive is dyed purple. This mixture of water and coolant
additive ...
© 2016-2026 Copyright www.vwpolo.net
