Volkswagen Polo Owners Manual: Test after driving for 10 minutes
First read and observe the introductory
information and safety warnings
Reconnect the tyre filler hose and check the tyre pressure on the tyre pressure display ⑥.
1.3 bar (19 psi / 130 kPA) and lower:
- Do not drive on! The tyre cannot be sealed adequately with the breakdown set.
- Seek expert assistance .
1.4 bar (20 psi / 140 kPA) and higher:
- Set the tyre pressure back to the correct value .
- Resume your journey to the nearest qualified workshop. Do not exceed a maximum speed of 80 km/h (50 mph).
- Have the damaged tyre replaced at the workshop.
WARNING
- Do not carry on driving if the tyre pressure is 1.3 bar (19 psi / 130 kPA) or lower.
- Seek expert assistance.
Sealing and inflating tyres
First read and observe the introductory
information and safety warnings
Sealing a tyre
Unscrew the cap from the tyre valve.
Use the valve core extractor to screw the valve core out of the ...
Fuses
...
Other materials:
Checking with Expansion Valve, Receiver/Dryer and A/C Compressor Regulator
Valve -N280-, Externally Regulated A/C Compressor
Specified Values
Note
Connecting service station. Refer to
→ Chapter „Connecting Service Station“.
Observe test requirements. Refer to
→ Chapter „P ...
Warning and indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Handbrake is applied.
Release the handbrake .
Brake system fault.
Do not drive on!
Obtain profe ...
Introduction
This chapter contains information on the following subjects:
→ Preparations for changing a wheel
→ Wheel bolts
→ Lifting the vehicle with the jack
→ Changing a wheel
→ After changing a wheel
Some models are delivered without a factory-fitted jack or ...
