This chapter contains information on the following subjects:
→ Warning lamp and coolant temperature display
→ Coolant specification
→ Checking the coolant level and refilling coolant
Never carry out any work on the engine coolant system if you are not familiar with the necessary procedures and if only unsuitable tools as well as incorrect operating equipment and fluids are available ! The work should be carried out by a qualified workshop if you are uncertain. Volkswagen recommends using a Volkswagen dealership for this purpose.
Serious injuries can be caused if work is carried out incorrectly.
Additional information and warnings:

WARNING
Coolant and coolant additives can pollute the environment. Spilt operating fluids must be collected and disposed of properly and with respect for the environment.
Coolant
Warning lamp and coolant temperature displayIndicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Engine management system fault (Electronic Power Control).
The engine should be checked by a qualified workshop
as s ...
Warning and indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Engine oil level is too low.
Switch off the engine. Check the engine oil level .
Fl ...
Checking with Expansion Valve, Receiver/Dryer and A/C Compressor Regulator
Valve -N280-, Externally Regulated A/C Compressor
Specified Values
Note
Connecting service station. Refer to
→ Chapter „Connecting Service Station“.
Observe test requirements. Refer to
→ Chapter „P ...